Car completely shuts off pulling into traffic randomly while still rolling. Car completely shuts off randomly while in reverse and continues to roll until brake is used. Dealership cannot diagnose problem. The car is presenting a very dangerous hazard while rolling into traffic randomly and while in reverse.

Source: NHTSA complaint ODI #11666871 · view all complaints for this vehicle at nhtsa.gov

The rear camera view that shows lines to assist in parking and taking the car out of the parking is so much misaligned that resulted my car hitting my garage when taking it out . Acura needs to address this to prevent the damages it can cause to the adjacent cars and properties

Source: NHTSA complaint ODI #11535953 · view all complaints for this vehicle at nhtsa.gov

The contact owns a 2024 Acura Integra. The contact stated that after pulling into a self-service car wash vacuum bay, the contact started drying the vehicle. The contact dried both the passenger-side front and rear doors, the trunk and the driver-side rear door. While drying the driver-side front door, the vehicle suddenly moved unintendedly about 15 ft. The contact grabbed the door frame and was eventually able to bring the vehicle to a stop, preventing a crash or injury. The vehicle was taken to the dealer, who was unable to duplicate the failure. The contact was initially informed that a manufacturer field technician would need to inspect the vehicle; however, the contact was later informed that the manufacturer had sent instructions on how to service the vehicle, which the contact deemed unsatisfactory due to the safety risk. Additionally, the contact stated that the vehicle had previously rolled after being parked and turned off, with the parking brake engaged. There was no warning light illuminated. Additionally, the contact stated that the TPMS reading had failed to display, the collision mitigation braking system had engaged erroneously, and the windows had rolled up and down unintendedly. The contact also stated driving at 5 MPH in a parking lot, an abnormal booming sound emanated from the passenger's side of the vehicle. The vehicle was not yet diagnosed or repaired. The manufacturer was contacted and filed a case. The failure mileage was approximately 4,558.

Source: NHTSA complaint ODI #11748770 · view all complaints for this vehicle at nhtsa.gov

Vehicle: 2024 Acura Integra Affected Component: Steering Gearbox Assembly / Electric Power Steering (EPS) Related Recall: NHTSA Campaign Number 24V-744 / Acura TSB 24-054 Description of Incident: My vehicle is actively experiencing the dangerous "sticky," heavy, and "notchy" steering defect outlined in NHTSA Campaign 24V-744, which causes a sudden increase in steering effort at highway speeds. The authorized franchise dealership previously performed the initial recall remedy (grease/spring kit replacement). However, this remedy completely failed to resolve the underlying manufacturing defect, and the hazardous steering behavior persists, making the vehicle unsafe to operate. Because I live on an isolated island with only one authorized Acura franchise facility, I have no alternative dealership options. The local dealership management and the visiting Acura Field Technical Specialist are formally refusing to diagnose, evaluate, or replace this defective steering rack. They are using the presence of an unrelated, aftermarket air suspension modification—which was installed after the failed recall attempt and does not physically obstruct the steering gearbox assembly—as a pretext to deny federal safety recall resolution and standard warranty repair. The manufacturer is failing to provide a successful remedy for an active, critical safety hazard. Furthermore, the local franchise facility has ordered me to remove this unsafe vehicle from their property, creating a severe safety risk. I am requesting immediate NHTSA intervention to ensure the manufacturer provides a complete and effective steering rack replacement as required by federal law.

Source: NHTSA complaint ODI #11746330 · view all complaints for this vehicle at nhtsa.gov

When in REVERSE the passenger mirror dips to give a better view of the curb. Once the vehicle is taken out of REVERSE the mirror does not return to the original position. I have had the vehicle in the dealership and they say they cannot reproduce the error. I have brought it in with the mirror in the dipped position. I have shown them videos of the mirror as it dips and then as it fails to return to the original position.

Source: NHTSA complaint ODI #11582815 · view all complaints for this vehicle at nhtsa.gov