Recalls
Safety issues the manufacturer must repair for free. A recall means confirm the fix was done, not walk away.
No recalls on record for this model
No safety recalls were found in this dataset. It is still worth entering the exact VIN on NHTSA before purchase, since recalls can be added at any time.
Owner complaints by system
Unverified reports owners filed with NHTSA, grouped by the part of the car. Useful for spotting patterns. Open a group to read recent examples.
Electrical & infotainment
3
Most reports here involve sudden stalling.
Read full complaint
The contact owns a 2020 Can-Am Spyder RT. The contact received notification of NHTSA Campaign Number: 23V175000 (Exterior Lighting); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was contacted. The manufacturer was not made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.
Source: NHTSA complaint ODI #11663696 · view all complaints for this vehicle at nhtsa.gov
Brakes
1
Most reports here involve other issues.
Read full complaint
The Spyder brake switch started failing with less than 14K miles on the vehicle. The driver my wife, did not know it was failing, only an engine code VSS would appear and the vehicle would go into limp home mode, until it could be restarted. Checking online forms, there were several post about the brake switch. I check in our garage and discovered I could push the brake pedal and sometimes there would be a two second delay before the lights would come on. Pressing harder on the brakes made them flicker on and off. At times only half the brake lights would come on. The brake switch is located four inches off the pavement and exposed to road grime. The piston only has an O-ring and lacks a rubber boot to keep debris from entering the switch. (Like my Harley Davidson motorcycle has.) The brake switch part # 710005480 is about $45 and an two hours labor to install. The new replacement switch is #710008326, but it looks just like the switch I took off the Can Am Spyder. Some of my research showed that this brake switch has been used on most if not all Spyders and Ryker motorcycles produced by Can Am in the last few years. I did post this issue on a Spyder Facebook group and within 24 hours eight people stated they had the same issue with their new Spyder, which was repaired under warranty. I just believe it's a bad design for an exposed part four inches off the pavement. Also my wife stepping on the brakes and the brake lights not working for two seconds put her in danger of being struck by another vehicle.
Source: NHTSA complaint ODI #11483449 · view all complaints for this vehicle at nhtsa.gov
Steering, suspension & tires
1
Most reports here involve other issues. Of these, 1 mention an injury.
Read full complaint
THE REAR AIRBACK SUSPENSION HAS BEEN BROKEN SINCE I PURCHASED THE MOTORCYCLE IN AUGUST 2020. A NEW SYSTEM HAS BEEN PUT IN BUT IT HAS ALSO FAILED. THIS MAKES THE MOTORCYCLE DANGEROUS TO RIDE. THE RIDE IS VERY HARD AND WHEN HITTING A BUMP, THE PASSENGER CAN FALL OFF.
Source: NHTSA complaint ODI #11365010 · view all complaints for this vehicle at nhtsa.gov
Structure & body
1
Most reports here involve other issues.
Source: NHTSA complaint ODI #11350371 · view all complaints for this vehicle at nhtsa.gov