Vehicle demonstrates an intermittent lag during acceleration, particularly during throttle position changes. Typical throttle response is appx 0.5s as measured by stopwatch. When the issue is replicated the delay can exceed 1 second. This is most concerning during situations where moderate to brisk acceleration is needed at a specific time such as turning across traffic at an intersection or merging with traffic flow with a large speed disparity from one lane to the other. Vehicle has been taken to multiple Ford dealerships multiple times. The ECU and TCU have been reprogrammed and the situation does not change. Dealership has noted an issue one time but otherwise claims that they have not been able to show the issue to be out of allowable parameters by Ford. Numerous forum posts online discuss the same symptoms and comment similar findings by Ford dealership techs. What they can readily replicate is understood but considered "normal". This behavior has created 2 different situations that nearly culminated in severe accidents with myself driving the vehicle, one time with my child in the seat exposed to oncoming traffic when the accelerator lag caused a severe situation. The first severe situation was crossing traffic outside of my child's school with oncoming traffic having to slam on brakes in order to avoid the collision. The second situation happened while merging lanes on a highway going from ~45mph up to ~60mph and almost caused the neighboring lane to rear end the vehicle. The dealerships have noted the delay exists but to be considered "within allowable limits" when it happens. No warning lamps come on as a regular pattern. This pattern first appeared when the vehicle was less than 500 miles on the odometer. The first dealership ignored the information.

Source: NHTSA complaint ODI #11760332 · view all complaints for this vehicle at nhtsa.gov

Vehicle: 2025 Ford F-150 (VIN and mileage available upon request) Component: Rearview/backup camera display, Accessory Protocol Interface Module (APIM) / SYNC infotainment system (Sync 4 version 25211 revision 1966-same CCPU ver./VMCU version:6.1.42.2) Summary of Problem: The rearview camera display intermittently shows a distorted, glitched, or corrupted image when the vehicle is shifted into Reverse. The fault is not consistent or reproducible on demand, it occurs unpredictably across different drive cycles, which makes it difficult to document with video or photo evidence at the time it occurs. When the fault is present, the driver does not have a reliable rear-view image, reducing visibility and situational awareness while backing up. I checked my VIN against Ford's and NHTSA's recall databases and found no open recall covering this specific vehicle for this issue. However, Ford has issued multiple prior recalls (including NHTSA 25V315 / Ford 25S49) for related APIM software defects causing rear camera freezing, blanking, or display corruption on other model years and vehicle lines. This suggests the underlying APIM/software issue may not be fully resolved across all affected builds, including 2025 model year trucks not currently covered. Safety Concern: Because the failure is intermittent and unpredictable, the driver cannot anticipate when the rear camera will be unreliable, which itself is a safety hazard distinct from a consistent failure that could at least be planned around. This creates a risk of collision with pedestrians, vehicles, or objects behind the truck during reversing, particularly since the rear camera is often relied on as a primary means of rear visibility. Additional Notes: I am in the process of documenting occurrences and requesting APIM diagnostic logs from Ford/dealer service to establish a pattern, given the intermittent nature of the fault.

Source: NHTSA complaint ODI #11762552 · view all complaints for this vehicle at nhtsa.gov

I want to include an important detail about the accident involving my 2025 Ford F-150 (VIN: [XXX] ). Immediately before the collision, I experienced a sudden change in braking. The brake pedal became very hard, and the vehicle did not slow as expected even with increased pressure on the pedal. This condition lasted for a few seconds and significantly reduced my ability to stop. The auto braking feature also did not activate. There were no clear warning indicators at the time, and the event happened very quickly. Based on how the vehicle responded, it felt like a loss of brake assist. My vehicle collided with a semi truck, totalling the front end. I was very lucky to walk away alive. Thankfully airbags and my seat belt saved me. I am reporting this as part of the incident record in case it is relevant to the cause of the accident. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Source: NHTSA complaint ODI #11733467 · view all complaints for this vehicle at nhtsa.gov

Vehicle experienced a flat tire on the side of a busy highway. The factory installed wheel rim was impossble to remove from the hub because it was corroded to the hub. Teo people had to stand in the traffic lane on an interstate highway to use mechanical leverage to remove the wheel. This vehicle is only 2 months old.

Source: NHTSA complaint ODI #11669676 · view all complaints for this vehicle at nhtsa.gov

The contact owns a 2025 Ford F-150. While the contact was driving at an undisclosed speed, the moonroof fractured without impact. The contact stated that there were no vehicles nearby and there was no impact to cause the failure. The vehicle was taken to the dealer; however, the vehicle was not inspected. The contact stated that the failure was a known failure with similar vehicles. The manufacturer was not made aware of the failure. The failure mileage was approximately 6,300.

Source: NHTSA complaint ODI #11753525 · view all complaints for this vehicle at nhtsa.gov