The contact owns a 2021 Ford F-250. The contact stated that while driving 55 MPH, the engine warning light illuminated and the message "LIMP Mode in 34 Miles" was displayed. The dealer was contacted. The vehicle was diagnosed with a diesel emission fuel injector failure. The contact associated the failure with NHTSA Campaign Number: 24V957000 (Fuel System, Diesel); however, the VIN was not included. The vehicle was being repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 56,000.

Source: NHTSA complaint ODI #11751901 · view all complaints for this vehicle at nhtsa.gov

The contact owns a 2021 Ford F-250. The contact stated that upon routine State Inspection at the local authorized dealer, the horn and the air bags failed to operate as intended. Upon further inspection, corrosion was found on the body control module from water leaking into the unit. The contact stated that the front passenger’s side windshield was loose, and pressure was applied, possibly causing the water to leak into the unit. The vehicle was not repaired because the VIN was not included in NHTSA Campaign Number: 21V090000 (Visibility). The manufacturer was made aware of the failure. The failure mileage was approximately 75,000.

Source: NHTSA complaint ODI #11746498 · view all complaints for this vehicle at nhtsa.gov

I have been experiencing a brake problem with the trailer brake system in my 2021 Ford F250 Crew Cab. When my travel trailer is connected to the truck the trailer brakes do not always apply and sometimes the brakes apply, then release and then apply again. On my most recent trip, I traveled half way through an intersection before stopping because the trailer brakes did not apply. The trailer brakes were replaced two years ago and were just inspected on January 27th of this year. They were rated in excellent condition. I took the trip soon after the trailer brakes were inspected and I still am experiencing trailer brake controller issues. I tested the condition at low speed just using the brake controller and the brakes applied then released and then applied again. I spoke with Ford today and they stated that the current recall campaign 25V132000 does not apply to my truck. I requested that they consider expanding the recall as my truck is exhibiting the exact conditions described in the recall. I am attempting to get the truck into the local Ford Dealer, but they are backed up four weeks until they can inspect the truck. This is a very dangerous situation and needs to be addressed.

Source: NHTSA complaint ODI #11717074 · view all complaints for this vehicle at nhtsa.gov

The contact owns a 2021 Ford F-250. The contact stated that while driving between 40 to 70 MPH and driving over speed bumps, uneven pavement, or potholes, the vehicle was pulling hard to the left, making it difficult to control the vehicle. The contact had experienced the Death Wobble while driving. The vehicle was not taken to be diagnosed or repaired. The contact related the failure to the Customer Satisfaction Program: 20N04 (Steering Linkage Damper); however, the VIN was not included. The manufacturer was notified of the failure and informed the contact that the vehicle was not included in the Customer Satisfaction Program. The failure mileage was 30,600.

Source: NHTSA complaint ODI #11683257 · view all complaints for this vehicle at nhtsa.gov

The contact called to file a complaint on a 2021 Ford F-250. The contact was a Crash Investigator. The contact stated that the vehicle owner was involved in a crash. The contact stated that while driving at an undisclosed speed in the opposite lane, the vehicle was involved in a head-on collision. No other information was available. The contact stated that while inspecting the Air Bag Control Module, it was downloaded; however, there was no reported crash data information of the crash or that the air bags were deployed. The contact stated that there was a pattern with the faulty part being distributed from a manufacturing plant for the manufacturer located in Kentucky. The contact stated that other similar vehicles had experienced similar failures. The contact was concerned that if vehicle owners were involved in a crash, none of the air bags modules would collect or store the data, making it difficult to investigate the crash. The contact stated that the failure was due to Air Bag Control Module, Event Data Recorder, and the Restraint Control Module not being able to download the needed information. The vehicle was towed and taken to the insurance company's lot. The manufacturer was notified of the issue. The failure mileage was not available.

Source: NHTSA complaint ODI #11712679 · view all complaints for this vehicle at nhtsa.gov

Back window has dropped 1/4 to 1/2 inch to the right. and is not in alignment. Safety concern that window could fall out or pop out during accident. No reason for window to just drop. Believe not installed correctly or sealants have failed cause of defect and window to drop and separate molding down to become detached right side. See pictures attached.

Source: NHTSA complaint ODI #11726718 · view all complaints for this vehicle at nhtsa.gov