Car stalls while driving and will not start again. No codes thrown. Found relay K96 on Junction Box Electronics module to have cracked through-hole solder joints resulting in bad continuity. Relay K96 supplies power to the low pressure fuel pump in the tank, thus with bad continuity, the pump gets no power. Relay K96 P/N is NEC Philippines P/N EP2F-B3G1ST. This issue has happened to many other people with the same car that I know. I suspect heat cycles over time stressed and fatigued the solder joints, causing the joint to crack. Overall the circuit board layout needs a heat sink for the relay to alleviate the heat produced from operation. I am IPC certified and work with aircraft engine electronics regularly and have seen similar issues.

Source: NHTSA complaint ODI #11634691 · view all complaints for this vehicle at nhtsa.gov

Failure of the Footwell Module failed due to corrosion by water intrusion as diagnosed by Mini Dealership. Windows, Turn signals and lights were inoperable as a result of failure. This matched the situation outlined in your recall notice Part 573 Safety Recall Report 23V-337. Car matched the model/years affected/listed in recall. However, Mini Dealer informed me my VIN was not listed in their recall. Subsequent research indicated that NHTSA/Mini limited the recall to cars purchased cars sold or registered in specific states (not part of the Safety recall report). Ref NEF-107DM dated 5/19/2023. I drove car in those states but did not buy or register the vehicle in them. I encourage you to have Mini extend it's recall/warranty to all vehicles which exhibit the safety failure.

Source: NHTSA complaint ODI #11675944 · view all complaints for this vehicle at nhtsa.gov