I have a 2024 Toyota Sequoia for the V35A twin-turbo V6 engine hybrid engine. My most recent oil change is showing signs for metal debris in the oil filter. Why is my vehicle not part of the engine recall?

Source: NHTSA complaint ODI #11759140 · view all complaints for this vehicle at nhtsa.gov

Component Affected: Exterior Lighting (Tail Lamps) / Electrical System. Description of Defect and Safety Hazard:The rear tail lamp assemblies on this 2024 Toyota Sequoia have suffered a major sealing and adhesive compromise, permitting road dirt and fine debris to bypass internal filters and permanently accumulate inside the housing. This is a progressive design defect identical to the one that triggered Toyota’s massive 443,000-unit rear-lighting safety recall (Recall 25TA14 / 25TB14) for platform-sharing Tundras.This constitutes an active safety hazard. The dense layer of road grime and permanent dust obscuring the interior lenses significantly degrades the lumen output, visibility, and daytime reflectivity of the brake lamps, turn signals, and rear running lights. This directly increases the risk of a rear-end collision, particularly in low-visibility or nighttime conditions. Furthermore, the persistent introduction of dirt and sand into an unsealed electronic housing risks premature circuit corrosion, electrical shorts, and complete illumination failure while the vehicle is in transit.Despite bringing the vehicle to two separate licensed dealerships (Daytona Toyota and Parks Toyota) within the original 3-year/36,000-mile factory bumper-to-bumper warranty window (current mileage: 35,821), Toyota and its regional distributor (Southeast Toyota) have refused to replace the defective assemblies, falsely categorizing a structural seal breach as normal environmental behavior.

Source: NHTSA complaint ODI #11744929 · view all complaints for this vehicle at nhtsa.gov

At every touch of the brakes, light or hard the breaks are extremely squeaky and ear piercingly loud. Toyota has told us a shim kit is available, however, they have been told they are not allowed to install any kits at this time even though they are available to purchase.

Source: NHTSA complaint ODI #11763587 · view all complaints for this vehicle at nhtsa.gov

I am submitting this complaint to raise serious safety concerns regarding the towing capabilities of the 2024 Toyota Sequoia. Despite its advertised towing capacity of up to 9,000 pounds, this vehicle is dangerously unstable when towing even modest travel trailers—particularly single axle models weighing around 4,500 pounds. During a recent vacation, I towed a properly loaded single axle travel trailer using my 2024 Sequoia. The trailer was equipped with: A weight distribution hitch Anti-sway bars Balanced tongue weight and cargo distribution Despite these precautions, the Sequoia was thrown around on the highway, requiring constant correction and resulting in a white-knuckle driving experience. My vacation was ruined, and my safety was put at risk. The trailer now sits unused in my driveway because I cannot safely tow it with this vehicle. The instability appears to stem from the Sequoia’s: Short wheelbase, which reduces towing control Soft suspension, tuned for comfort rather than trailer handling Hybrid drivetrain weight distribution, which may compromise rear-end stability These design choices make the Sequoia unsuitable for towing travel trailers, even well below its rated capacity. RV dealerships, including Camping World, routinely sell trailers to Sequoia owners based solely on the published tow rating. There is no warning or advisory provided about the vehicle’s real-world towing limitations. This practice is misleading and dangerous. I urge Toyota and the NHTSA to take the following steps: Issue a Technical Service Bulletin (TSB) or formal advisory warning owners about towing instability with the Sequoia. Educate RV dealerships about the limitations of SUV towing dynamics, especially with single axle travel trailers. Investigate owner complaints and consider a broader safety review of the Sequoia’s towing performance. There are multiple online reports and forums where Sequoia owners share similar experiences. This is not an isolated incident—it is a sys

Source: NHTSA complaint ODI #11679524 · view all complaints for this vehicle at nhtsa.gov

The second row right seat belt receptacle wiring harness failed on my 2024 Toyota Sequoia. The two wires connecting the seat belt buckle sensor were severed cleanly. The wiring harness is routed through the seat fold/pivot mechanism with insufficient slack or protection. Normal use of the fold-flat seat function caused the harness to be pinched and abraded at the pivot point over time, eventually shearing the wires completely. The seat belt alarm activated continuously even when buckled, as the sensor could no longer detect buckle engagement. The dealer inspected the vehicle and attributed the damage to user fault, declining warranty coverage. Upon self-repair, the cause was clearly mechanical — the harness routing places the wires directly in the path of the seat pivot with no grommet or strain relief. This is a design defect that poses a safety risk, as a non-functioning seat belt sensor may give false readings about buckle status. The failed component is available for inspection.

Source: NHTSA complaint ODI #11731505 · view all complaints for this vehicle at nhtsa.gov

The power liftgate and pinch sensor system on my 2024 Toyota Sequoia Platinum continues to malfunction intermittently and creates an ongoing safety concern. The liftgate frequently fails to close using the electronic controls and instead emits two warning beeps before becoming completely unresponsive, forcing the liftgate to be manually pushed shut. The pinch sensor system appears to falsely detect obstructions when none are present, causing unreliable and inconsistent operation of the rear liftgate. Because this is a powered safety-related system, the intermittent failure raises serious concerns regarding occupant safety, system reliability, and the ability to properly secure the rear hatch while the vehicle is in operation. This issue has persisted despite dealership involvement and does not appear to be an isolated incident. Multiple owners have reported similar failures involving the Sequoia liftgate and pinch sensor system. Toyota has not provided a permanent corrective action. For a vehicle at this price point, repeated failures of a powered liftgate safety system are unacceptable. The defect creates the potential for injury, improper liftgate closure, and unsafe vehicle operation. I am requesting that NHTSA investigate this issue for a broader defect pattern and determine whether a recall or manufacturer-required corrective action is warranted.

Source: NHTSA complaint ODI #11740250 · view all complaints for this vehicle at nhtsa.gov

The plastic panel underneath the driver’s seat has cracked and broken a SECOND time, despite being repaired at Toyota dealership. Toyota customer care was contacted and while they admitted this is a known issue and they are aware it is happening repeatedly, even after a few months after being replaced there is no fix in sight and they will not cover the repair. Size should not matter but I am a smaller person and not applying excess force when seated. I am worried about SAFETY as a secure seat that doesn’t move and break while buckled should be expected and required.

Source: NHTSA complaint ODI #11737329 · view all complaints for this vehicle at nhtsa.gov