Recalls
Safety issues the manufacturer must repair for free. A recall means confirm the fix was done, not walk away.
No recalls on record for this model
No safety recalls were found in this dataset. It is still worth entering the exact VIN on NHTSA before purchase, since recalls can be added at any time.
Owner complaints by system
Unverified reports owners filed with NHTSA, grouped by the part of the car. Useful for spotting patterns. Open a group to read recent examples.
Electrical & infotainment
12
Most reports here involve electrical shorts.
Read full complaint
1. An ATP connector on a solar charging system experienced a high resistance event and started a smoldering fire. It melted the connector and about 24" of 10 gauge wiring. It also melted the fiberglass roof material under the connector. The event was observed on Sunday morning, April 19, 2026 at approximately 9:30 am. It occurred while parked in our driveway. We disconnected the solar panel that was feeding this wire to remove the resistance to the system and stop the damage from spreading. 2. Had we not seen the smoke, a major fire could have destroyed the RV and endangered our house. 3. Problem was reported to the manufacturer who seemed most concerned that the RV was no longer in warranty. The damage was observed and repaired by a factory authorized service center on Monday, April 27, 2026. 4. There were no warnings.
Source: NHTSA complaint ODI #11737377 · view all complaints for this vehicle at nhtsa.gov
Brakes
1
Most reports here involve loss of braking.
Read full complaint
Brakes went out while driving on 77n. In viginia. Once we were anle to get to the side of the road realized we were on fire. Ford dealership determined the fire burnt the brake lines boiling fluid pushing it back through master cylinder knocking out my brakes.
Source: NHTSA complaint ODI #11757112 · view all complaints for this vehicle at nhtsa.gov
Other systems
1
Most reports here involve electrical shorts.
Read full complaint
The A/C on our 24E/24T EKKO stopped working today, October 13, on old Route 66 in Oklahoma. The ICM870-16A-BH5400 easy start circuit board was fried. A portion of the circuit board had melted and the brown wire was loose and the connector melted. The ICM cover fell loose when I removed the GE A/C cover. See the attached photos. The ICM870-16A-BH5400 is included in GE Kit GEASST-1. The BH5400 suffix is unique to the GE sourced easy start. This may not be important, but upon inspection, using ICM680 installation instructions on-line (see attached), I noticed that the red and white/blue wires from the ICM controller were switched on the run capacitor H and C terminals. I assumed that the wire colors shown on the installation wiring diagrams are the same for all ICM680 controllers and all applications. If the installations are the same for all ICM680 controllers, then the red wire from the ICM controller is to be connected to the run capacitor on the C post. On our unit, the red wire is connected to the run capacitor H post and the white wire is connected to the C capacitor post. The wiring diagram on the blackened ICM cover, shows the red wire attached to the capacitor H post (also attached to the motor S post) and the white wire to the C post. As a reference, I am attaching the ICM680 installation instruction wiring diagrams found on web as well as written instructions. I could NOT find a wiring diagram like what is shown on our blackened ICM cover with the red wire attached to the H post. The QR Code for online installations on our blackened ICM680 cover resulted in a 404 Not Found notice. I called ICM technical service but could not leave a message as the voice mailbox was full. No serial number could be found on the ICM box. See the attached photos of the fried controller and the ISM wires attached to the run capacitor with the red and white wires reversed from what is shown on the wiring diagrams.
Source: NHTSA complaint ODI #11621634 · view all complaints for this vehicle at nhtsa.gov