The contact owns a 2020 Buick Enclave. The contact stated that while driving at an undisclosed speed, the accelerator pedal was depressed; however, the vehicle failed to accelerate as intended. The vehicle lost motive power and was coasted to the shoulder of the roadway. No warning light was illuminated. The vehicle was towed to the dealer where it was diagnosed with transmission failure. The contact was informed that the transmission needed to be replaced. The vehicle was in the process of being repaired. The manufacturer was made aware of the failure, and a case was filed. The contact was advised to contact the NHTSA Hotline to report the failure. The failure mileage was approximately 45,684.

Source: NHTSA complaint ODI #11744760 · view all complaints for this vehicle at nhtsa.gov

Back up Camera has stopped working. When placing car into reverse we get a black screen with a warning signal and picture of camera with line through. this creates a safety issue when backing up with out camera guidance.

Source: NHTSA complaint ODI #11730315 · view all complaints for this vehicle at nhtsa.gov

Vehicle suffered a catastrophic, uncommanded electronic and mechanical system failure within 30 days of purchase, resulting in a severe crash.Prior to the incident, the vehicle exhibited a violent, unexpected jerking motion while accelerating up a highway on-ramp, though control was briefly regained. A few days later at the end of May, while driving in the rain, the electronic systems completely failed with zero dashboard warning lights or error messages appearing.The vehicle completely overrode driver input, veering uncontrollably from lane to lane on its own. Simultaneously, a total loss of braking power occurred; pressing the brake pedal had no effect on reducing the vehicle's speed. To stop the runaway vehicle and prevent hitting other drivers, I was forced to intentionally steer the SUV into a physical wall. The impact deployed components, caused orange engine coolant to leak, and forced the electronic precision shifter into Neutral on its own before the vehicle lost all electrical power. The steering wheel airbag deployed during this initial impact.Approximately 5 minutes later, while the vehicle was disabled on the road and after I had safely exited, a secondary vehicle struck my stationary car, which caused the majority of the remaining airbags to deploy.Detroit Police responded to the scene and filed an official crash report noting that I 'lost control' and struck the wall, but the responding officer failed to document the mechanical/electronic brake and steering failure reported at the scene.This simultaneous loss of eBoost braking control and electronic steering assist strongly aligns with the current federal safety investigation into GM vehicles (NHTSA Case PE24011). The vehicle is currently parked and being preserved exactly as-is at my residence to serve as evidence, as the module memory holds the Event Data Recorder (EDR) data proving full brake application during the failure. I am requesting an immediate investigation into this VIN.

Source: NHTSA complaint ODI #11764882 · view all complaints for this vehicle at nhtsa.gov

I am submitting this complaint regarding a paint defect on my 2020 Buick Enclave. The passenger-side rear door has significant top-coat peeling and flaking, exposing the primer and metal underneath. This deterioration is not normal wear for a six-year-old vehicle that has been properly maintained and protected from environmental conditions. The pattern of peeling indicates a failure of the top coat or clear coat applied during manufacturing. The paint layers are separating prematurely, reducing corrosion protection and long-term durability. Exposed metal increases the risk of rust, structural weakening, and potential failure of the door panel, which may affect occupant safety in the event of a collision. I am aware that similar paint adhesion failures have been reported across multiple General Motors vehicles, and class-action lawsuits are currently pending alleging defective basecoat and clearcoat systems that cause premature peeling, bubbling, and flaking. The number of complaints suggests a broader manufacturing issue rather than isolated consumer misuse. Although my vehicle’s limited warranty has expired, the defect is clearly premature and manufacturing-related. A properly applied top coat should not fail this early, especially on a vehicle that has been routinely washed, waxed, and stored in normal conditions. I respectfully request that NHTSA review this issue and consider opening an investigation into paint top-coat failures on Buick and other GM vehicles. Premature paint failure affects corrosion resistance, vehicle longevity, and consumer value, and may compromise the safety of occupants and other drivers if corrosion spreads or structural integrity is reduced. I am willing to provide photographs, documentation, and maintenance records to support this complaint. Thank you for your attention to this matter and for your commitment to consumer safety and manufacturing accountability.

Source: NHTSA complaint ODI #11748311 · view all complaints for this vehicle at nhtsa.gov

My car starting making a loud noise upon start up and continued while driving, sounded like a GoCart exhaust system and was not normal. It just sounded loud and would get louder when accelerated until the car ran for awhile. I first noticed it at about 83,500 miles. I took to the dealer for checkup at 83,950 miles when I could get an appointment. The dealer (Elco Chevrolet) confirmed the problem upon hearing and looking under the car, there is a bracket broken on the exhaust system and the catalytic converter has a hole/crack in the molding. Our safety is at risk if the exhaust with the crack would create fumes harmful when driving the car and risk of injury if the exhaust would fall off upon driving due to bracket broke. There were no warning lamps or messages from the car. I am submitting this problem as upon discussion with the dealer and investigation online about this, appears that this is a problem with GM vehicles with this make and model, Enclave and Travers, however, my year was not flagged for a recall already established. When I tried to investigate with GM they stated it was because my car was not identified likely due to parts or timing. I am asking to further investigate as there may be a problem with the design of this exhaust system that caused this issue early in the mileage of this car. Asking for further investigation into the make and model of this year for the year 2020.

Source: NHTSA complaint ODI #11755725 · view all complaints for this vehicle at nhtsa.gov